Ehpro Tobh V2.5 Clone Atomizer (RDA)
(3 Post - Drip Style)
ADVANCED USERS ONLY
The Tobh V2.5 Atomizer (RDA) is made from stainless steel and consists of 4 pieces (including drip tip). The building deck has three posts to suit most custom coil/wick builds and a large dripping well to hold more e-liquid. The deck has two O rings to ensure a tight seal to the adjustable air flow control which utilizes six holes that can be turned to give different levels of draw. On top of the air flow tube is a large heatsink that disapates heat. Inside the heatsink is a conical (chimney) to decrease turbulent airflow. The 510 center connection is made from copper to offer a strong conductivity and performance.
Colors:
Includes:
- Tobh V2.5 (RBA) Atomizer
- Drip Tip
- Wick/Wire
- Extra O-Rings
NOTE: The Tobh V2.5 is an upgraded version of the Tobh V2.


Rebuildable atomizers (RBA or RDA) are for experienced users and require knowledge of basic electronic fundamentals to properly use. Rebuildable atomizers (RBA - RDA) users MUST have knowledge of how different thicknesses of coiled wire (Coils / Wicks) can vary in Ohms. The use of a multimeter to verify the Ohms of each and every coil made is mandatory. These materials cannot be safely used by the inexperienced or those without basic knowledge of electronic MOD and Lithium Ion devices.
This is because:
1. A rebuildable coil/wick MUST be made in accordance with the specific device being used. tested carefully with a meter before it is used.
2. A rebuildable coil/wick MUST be carefully tested with a multimeter before use. If it is not, it is entirely at the risk of the user.
3. Once tested on a multimeter, the new coil/wick MUST be used on a strong basic electronical MOD that has short circuit protection.
4. To reiterate, NO built coil/wick should be used on an electronical device until it is known to be safely functioning.
5. Faulty wicks/coils can and will destroy the electronics. (ie. Batteries, MOD Batteries and MOD Devices)
6. It cannot be said enough that rebuildable coil/wicks can and will destroy electronic devices if faulty.
Route 66 Vapor shall not be liable for any special or consequential damages that result from the use of, or the inability to use, the materials on this site or the performance of the products, even if Route 66 Vapor has been advised of the possibility of such damages.